I took part in a Christmas Ornament Exchange with a number of artists that I met on line this year from Kelly Rae Roberts ecourse and I wanted to share with you how to make the ornament that I created.
The ornament is a basically a domino that I altered with a piece of my art and some vintage crystals and beads. You'll also need diamond glaze, a couple of bails, a strong glue to attach the bails to the domino, a few jump rings and a piece of ribbon to hang.
You can download the my art for the bird design here .... please note that this download is for PERSONAL USE ONLY. You cannot use it in any commerical way, alter or sell it as your own. Please do not share this download with anyone ... you may refer friends to my blog for them to download themselves.
The first thing you need to do is to print my art. It was created as a 4x6 jpeg so you can print it at Costco or where you do your photo printing. I don't recommend printing these on an ink jet printer ... we are going to add diamond glaze to the image and it may bleed. One 4x6 print contains enough art to make 6 ornaments. You will need to cut out each piece to fit the domino ... there is a bleed so you will trim smaller than what you see on the printout.
Next you will want to adhere the art to the back of the domino ... I used glossy accents but modge podge or any type of glue will work. Once it is dry trim off or sand the edges of the paper to make sure that the edges are clean and straight.
The next step is to give the ornament a glossy coat ... I did that by adding glossy accents to the photo being careful not to add too much that it spills over the edges of the domino. Let it dry for a few hours depending on how much diamond glaze you used. It is really important that the glaze is completely dry before going onto the next step because we are going to turn the domino over and work on the back ... if in doubt ... wait!!!
Using a strong glue you need to attach bails as shown to the domino. If you don't want to add the crystal and bead to the bottom of the domino just add one bail to the top for hanging.
After the glue has dried and the bails are secure it's time to add some bling. Use whatever you have on hand or can find at your favourite craft/scrapbooking store. I used a vintage crystal and a crystal bead on mine ... I simply attached them with jump rings (I added a wire to the bead for hanging first).
Then you just need to add a ribbon to the top and hang it on the tree!
Here's a picture of the ornaments that I've received so far from my "Flying Friends" ... Suzanna Leigh, Rebecca Everett, Kathrin Rasser, Kris Johnson and Dayle Achatz Micoff.